Specifications

Page 6 Installation Instructions
INW-AM325
1. To attach the side covers, use four (4) #14 x 1-1/4” wood screws to attach the side covers.
2. Line up the mounting holes on the side covers with the mounting holes that are located on the INW-AM325.
3. Once the mounting holes are aligned, insert the four (4) #14 x 1-1/4” wood screws and tighten.
INW-AM325 Installation Complete
Side Cover Installation
When attaching the side covers, make sure that the
1/4” wood shims are in line with the side cover
mounting holes. If the wood shims split while
attaching the wood screw, don't panic. These wood
shims have been designed to split in half to cover
more area.
In-Wall Electrical Box Installation
It is best to have a professional install this product.
It is strongly recommended that a licensed electrician be hired to supply wire and power to the in-wall mount. Wiring
must be ran prior to installing the INW-AM325. The cutout in the mounting box is sized to accommodate a standard
RACO junction box. Route all audio/ visual cables and power wires through the cutouts.
1. Use two (2) 6-32 x 1/2” Phillips screws to attach the electrical box to the mounting box.
2. The remaining 6-32 x 1/2” Phillips screws will be used to attach the electrical outlet to the electrical box (see NOTE above).