Specifications

Fine Tune Projector Mount
Page 8 Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
Installing the Fine Tune Projector Mount (cont’d)
Remove the Installation Disk and set it aside.
Drill a pilot hole in the center of each mark using a power
drill and
1
/8˝ drill bit.
Pilot Holes
When a screw is driven into a material, such as
wood, it can act as a wedge, generating outward
pressure which can cause many materials to split.
Drilling a small pilot hole in the material into which
the screw will be driven causes less ‘wedging’ to
take place, thereby reducing the likelihood of the
material being split. It also reduces the possibility
of the screw head from being sheared off by torque.
1) Place the Installation Disk against the ceiling with the
mounting holes aligned with the center of the ceiling
stud.
2) Use a pencil and mark two (2) mounting hole
locations through the holes in the Installation Disk.
Step 3
Wood Stud Installation
Step 1
1) Use a stud nder to locate a ceiling stud closest to
your desired installation location.
2) Identify the center of the ceiling stud.
3) Use a pencil to mark the location of the ceiling stud
center.
Be sure to only install on ceiling with a max drywall
thickness of 5/8”.
Step 2
Stud
Center