Specifications

Fine Tune Projector Mount
Installation Instructions Visit the Premier Mounts website at http://www.mounts.com Page 7
Step 2
1) Attach a 6˝ or longer socket wrench extension onto a
socket wrench.
2) Insert the end of the socket wrench extension into
the center of the Installation Disk, then insert the
Installation Disk into the underside of the FTP Dome.
Note the arrow inscribed inside of the FTP Dome.
Step 3
Tighten the FTP Dome until the inscribed arrow on the
underside of the FTP Dome points in the direction in
which the projector will be facing.
If the FTP Dome becomes too tight to turn and the
inscribed arrow is pointing away from the projector screen
by more than 5˚, loosen the FTP Dome one (1) rotation
until the inscribed arrow points towards the projector
screen.
The “Alignment & Fine-Tuning” section of this manual
describes how you can ne-tune the roll, pitch, and yaw
of the projector.
Remove the Installation Disk and store it in a safe
location.
Step 4
Installing the Fine Tune Projector Mount (cont’d)
Secure the FTP Dome to the pipe with one (1) M6 x 6mm
set screw and tighten it using the M3 Allen wrench.
You can use either the standard hardware or
Lock-It™ security hardware.
Proceed to the “Attaching the Universal Projector
Plate” section.
FTP Dome as Viewed from Below
Inscribed Arrow