Specifications

Fine Tune Projector Mount
Page 14 Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
If your projector is heavy and/or bulky, two people may be required to safely attach your projector to the FTP
Dome.
If your projector is to be mounted higher than shoulder height, you may need to use one or more ladders to safely
attach your projector to the FTP Dome.
Verify that the FTP Dome is in the factory-default position prior to attempting to attach the Quick Set Base/
projector assembly. Serious damage to property or severe personal injury could occur if the FTP Dome is not at
the factory-set position.
1) Raise the projector (with the Quick Set Base and Universal Projector Plate securely attached) and slide the Quick
Set Base onto the FTP Dome. Do not release the projector.
2) Use your thumb and forenger to thread the Captive Screw into the FTP Dome until it is hand-tight.
3) Insert the M5 x 12mm screw into the location shown and tighten it using a Phillips screwdriver.
You can use either the standard Phillips head or Key Lock security hardware.
Do not overtighten the M5 x 12mm screw.
Proceed to the “Alignment & Fine-Tuning” section.
Attaching the Projector to the Mount
Securing the Quick Set Base
You had the option of installing Lock-It™ security
hardware during several of the previous steps. You may
also exchange the screws which secure the Universal
Projector Plate to the Quick Set Base.
1) Remove the four (4) Phillips head M6 x 8mm screws
which secure the Quick Set Base to the Universal
Projector Plate.
2) Replace each M6 x 8mm Phillips head screw with
one (1) M6 x 8mm Security screw.
3) Tighten all screws.
Do not overtighten the mounting screws.
Proceed to the “Attaching the Projector to the Mount”
section.
Captive
Screw