Specifications

Fine Tune Projector Mount
Installation Instructions Visit the Premier Mounts website at http://www.mounts.com Page 11
Multiple Mount Point Installation
Step 1
1) Locate the projector’s mount points.
2) Position an appropriate number of mounting legs on
the projector.
The four long mounting legs come pre-installed, but you
can use three (3) or four (4) long and/or short mounting
legs depending on what your projector requires.
The number and placement of mount points
on projectors varies between projector
manufacturers. This example projector has ve
(5) mount points, but only uses four (4) mounting
legs.
Step 2
Insert the mounting hardware, as determined in the
“Selecting the Mounting Hardware” section, through
the leveling barrels of the mounting legs into the thread
insert of the projector.
You can use either the standard Phillips head or
Lock-It™ security hardware.
Do not tighten the mounting hardware at this time.
Attaching the Universal Projector Plate (cont’d)
Mounting Hardware Too Long?
The depth of some projector mount points may
prevent you from tightening the M2.5 and M3
mounting hardware.
You can reduce the length of the M2.5 and
M3 mounting hardware by stacking up to a
maximum of ve (5) M3 at washers inside the
leveling barrel.
Avoid stacking too many M3 washers; the
mounting hardware must thread into the
projector mount point at least four (4) complete
turns.
Projector plate not
shown