Specifications

Fine Tune Projector Mount
Page 10 Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
Selecting the Mounting Hardware
1) Insert a small straw or toothpick into the threaded
inserts found on the bottom or top of the projector.
2) Use a pencil to mark the depth of the threaded insert
on the small straw or toothpick.
3) Mark the straw or toothpick 1/8” above the depth of
the threaded insert, as shown in Figure 1.
4) Insert the small straw or toothpick into the remaining
threaded inserts to compare and verify their depth
using the straw or toothpick’s 1/8” allowance mark.
5) Locate the correct diameter screw for the threaded
insert.
If the screw you selected is longer than the 1/8”
allowance mark on the small straw or toothpick,
as shown in Figure 2 and Figure 3, do not use this
screw. The screw length must not bypass the mark.
6) Test each size of the screws provided.
The correct screws should thread easily into the
mounting point and not pull out when tension is
applied.
Does your projector have multiple mount points or a
single mount point?
If your projector has multiple mount points, proceed
to the “Multiple Mount Point Installation” section.
If your projector has a single mount point, remove
the pre-installed mounting legs on the universal
projector plate and skip to the “Single Mount
Point Installation” section.
Attaching the Universal Projector Plate
Small Straw or Toothpick
Small Straw
or Toothpick
Small Straw
or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark