Specifications
Page 10 Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
EST100/EST200
Step 2
Attach the mounting legs to the projector using the corresponding mounting
hardware.
Do not tighten the mounting hardware at this time.
Multiple Mounting Point Installation
Step 1
Locate the projector’s mounting points.
Position the mounting legs on the projector.
The mounting legs are pre-installed. Depending on the requirements of your
projector, you may remove one of the mounting legs.
The number and placement of mounting points on projectors varies
between projector manufacturers. Refer to you projector’s technical
specications for the number and location of the mounting points on
your specic projector.
Step 3
If the mounting legs need to be leveled, rotate the leveling barrels to level the
mounting bracket.
To raise the mounting legs, rotate the leveling barrel clock-wise. To lower the
mounting leg, rotate the leveling barrel counter clock-wise.
Raise or lower each of the mounting legs, by rotating the leveling barrels,
until all of the mounting legs are at an equal height.
• Lower the mounting leg by rotating the leveling
barrel counter-clockwise.
• Raise the mounting legs by rotating the leveling
barrel clockwise.
When the desired position is achieved, tighten the mounting screws to the
projector and then tighten the hex head leg screws with the M5 Allen wrench.
Screws shown for illustration
purposes only.
Mount carriage not shown.