Specifications

Page 4 Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
EST100/EST200
THE EXACT CENTER OF THE STUD MUST BE LOCATED FOR CORRECT AND SAFE INSTALLATION.
Do NOT over-tighten lag bolts when attaching the mount to the wall. Improper installation may result in personal
injury or damage to property.
Warning
Step 1
Step 2
Step 3
Are you installing the single-stud EST100 or the dual-stud EST200?
If EST100, continue to the “EST100 Installation” section below.
If EST200, go to the “EST200 Installation” section on page 8.
EST100 Installation
After the pilot holes have been drilled, use
two (2) #14 x 2˝ wood screws to mount the projector arm to the wooden stud.
Once the mounting points have been marked, use a
⅛˝ drill bit and portable drill to drill the pilot holes.
Drill
Marking
Wood Stud
Marking
Projector
Arm
#14 x 2” Wood Screw
Use two (2) M5 x 10mm security screws to attach the projector arm cover plate
to the projector arm.
Wood stud not shown
Go to the “Throw Distance Calculation” section on
page 10.