ECM-4000 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids Elliptical Ceiling Mount for 37˝ to 63˝ Flat Panels Model: ECM-4000 Warranty, Garantie, Garantía, Garanzia, Garantie, Waarborg: http://www.mounts.com/warranty www.mounts.com | North America 800.368.9700 | International +1-714-632-7100 1321 S. State College Blvd., Fullerton, CA 92831 USA 9531-000-000-0X Rev.
80 lb.
ECM-4000 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids Insert the Thread Depth Indicator into the thread inserts found on the bottom or top of the projector. Use a pencil to mark the depth of the thread insert on the Thread Depth Indicator, as shown. Insert the Thread Depth Indicator into the remaining thread inserts to compare and verify their depth.
Premier Mounts’ nylon spacers allow you to attach the mounting bracket to flat panels which have recessed or uneven mount points. Each nylon spacer will add distance between the mounting bracket and your flat panel. 4 The nylon spacers must only be installed between the mounting bracket and your flat panel. The nylon spacers will fit M4, M5, M6 and M8 screw sizes.
ECM-4000 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids Install the mount according to the instructions provided by Premier Mounts. Ensure all structural reinforcements have been made before attaching the flat panel to the ECM-4000. 6 Do not release the flat panel until the mounting bracket arms are fully resting on the elliptical mounting bar.
When attaching the decorative covers, verify that the smaller mounting hole is above the larger mounting hole. 8 Place the first decorative cover over the first mounting Decorative Cover bracket arm and push firmly into place. Align the mounting holes together. Insert the M4 x 6mm Phillips screw (smaller mounting hole). Insert the M6 x 25mm Phillips screw (larger mounting hole). Use a screwdriver to tighten all decorative cover mounting hardware.
ECM-4000 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids Adjusting the Flat Panel Friction Tilt Angle 10 Place one hand at the center top edge of the flat panel. Place the other hand on the center bottom edge of the flat panel. Using the upper hand, gently pull the top of the flat panel towards you while the lower hand gently pushes the bottom of the flat panel away from you.
ECM-4000 Installation Guide Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids PREMIER MOUNTS LIMITED LIFETIME WARRANTY What and Who is Covered by this Limited Lifetime Warranty Premier Mounts warrants all mounting products to be free from defects in material and workmanship for the lifetime of the original installation of the product.
