Specifications

CTM-MS2
Installation Instructions Visit the Premier Mounts website at http://www.premiermounts.com Page 9
Installing the Mounting Brackets (cont’d)
Griplate™ Installation
Flat Panel
Universal Washer
Universal Spacer
Mounting Bracket
Mount Point
Mounting Screw
Premier Mounts’ Universal Washers are designed to
accommodate the various M4, M5, M6 and M8 hole
sizes required by at panels.
Do not place excessive pressure on the back of
the at panel, as this may damage the at panel.
The Universal Washer must be installed between
the head of the mounting screw and the mounting
bracket as shown.
Does the at panel have:
● Recessed mount points?
● Uneven mount points?
● A curved back?
● Any obstruction near the mount point?
If Yes, you must install Universal Spacers. Remove the
mounting brackets, Universal Washers, and mounting
screws from the back of the at panel. Proceed to the
“Universal Spacer Installation” below.
If No, skip to the “Attaching the Mounting Bracket to
the Flat Panel” on page 10.
Universal Spacer Installation
Premier Mounts’ Universal Spacers allow you to
attach the mounting bracket to at panels which have
recessed or uneven mount points. Each Universal
Spacer adds ¼˝ to the distance between the mounting
bracket and the at panel.
The Universal Spacers must be stacked and
oriented as shown.
The Universal Spacers must only be installed
between the mounting bracket and the at panel.
The Universal Spacers will t M4, M5, M6 and M8
screw sizes.
Proceed to the “Attaching the Mounting Bracket to
the Flat Panel” section.
M8
M5, M6
M4
1˝ ¼˝