Specifications

CTM-MS2
Installation Instructions Visit the Premier Mounts website at http://www.premiermounts.com Page 7
Installing the Wall Plate (cont’d)
➊
Place the wall plate against the wall and align it with
the pilot hole.
➋
Insert one (1)
5
/16˝ x 3˝ lag bolt and one (1)
5
/16˝
washer into the upper right pilot hole.
➌
Use a socket wrench and a ½˝ socket to tighten the
lag bolt.
Do not overtighten the lag bolt.
Step 4
Step 5
Step 6
➊
Level the wall plate.
➋
Use a pencil to mark the remaining ve (5) mounting
locations along the center of each wall stud.
Two people are recommended for this step; one
person to level the wall plate and another person
to drill the pilot holes.
Drill a “pilot hole” in the center of each of the marks with
a power drill and a ¼″ drill bit.
Only use ¼″ drill bit when drilling the pilot holes.
Step 7
➊
Insert one (1)
5
/16″ x 3″ lag bolt and one (1)
5
/16″
washer into each pilot hole
➋
Tighten all lag bolts using a socket wrench and ½″
socket.
Do not overtighten the lag bolts when attaching
the mount to the wall. Improper installation may
result in personal injury or property damage.
Proceed to the “Installing the Mounting Bracket” on
page 8.