Specifications

CTM-MS2
Page 12 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
Locking Safety Screw Installation
The locking safety screws keep the at panel from
being accidently dislodged from the CTM-MS2.
➊
Thread an M6 x 30mm locking safety screw at the
bottom of one of the mounting brackets.
➋
Use a Phillips head screwdriver to tighten the
locking safety screw.
➌
Repeat steps 1 and 2 for the other locking safety
screw.
Do not overtighten the locking safety screws.
Tilt Adjustment
Adjusting the Flat Panel Friction Tilt Angle
➊
Place one hand at the center top edge of the at
panel.
➋
Place the other hand on the center bottom edge of
the at panel.
➌
Using the upper hand, gently pull the top of the
at panel towards you while the lower hand gently
pushes the bottom of the at panel away from you.
Adjusting the Flat Panel to the Original Position
➊
Place one hand at the center top edge of the at
panel.
➋
Place the other hand on the center bottom edge of
the at panel.
➌
Using the upper hand, gently push the top of the at
panel towards the wall while the lower hand gently
pulls the bottom of the at panel away from the wall.
M6 x 30mm
Locking Safety Screw
(1 per Bracket)
Proceed to the “Installing the Mounting Bracket”
below.