Specifications

CTM-MS2
Page 10 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
Installing the Mounting Brackets (cont’d)
This section presumes that you have read and
understood these sections:
● Selecting the Proper Mounting Hardware
● Universal Washer Installation
● Universal Spacer Installation
➊
Place your at panel screen-side down on a soft, at
surface.
➋
Identify the number and location of the thread
inserts on the back of your at panel.
➌
Aligning the holes on each mounting bracket with
the thread inserts on the back of your at panel.
➍
Secure each mounting bracket to your at panel by
inserting a minimum of two (2) screws per bracket.
Do not overtighten the mounting hardware.
Attaching the Mounting Brackets to the Flat Panel
Attaching the Flat Panel to the Wall Plate
Mounting the Flat Panel
This section requires two people.
Do not release your at panel until you are certain
that top and bottom hooks of both mounting
brackets are securely seated on the upper and
lower mounting rails of the wall panel.
➊
Raise the at panel past the top and bottom
mounting rails on the wall panel.
➋
Slide the at panel down slowly, keeping it close to
the wall.
➌
Engage the top and bottom mounting brackets to
the rails of the wall plate.
Proceed to the “Mounting the Flat Panel” below.