Specifications

AM300/AM300-B
Installation Instructions Visit the Premier Mounts website at http://www.mounts.com Page 9
Installing the Swingout Arm (cont’d)
Step 2
Step 3

Set aside your Swingout Arm.
®
Use a power drill and concrete drill bit to drill holes at
the marks.
¯
Insert a wedge anchor into each hole.
°
If necessary, use a hammer to lightly tap each wedge
anchor into place so that they are ush with the wall.

Move your Swingout Arm back into position.
®
Attach the wedge anchor nut and washer onto the
threaded shaft that is protruding from the wall.
¯
Do not tighten any hardware until all wedge anchor
nuts and washers are in place.
Proceed to the “Mounting Hardware Selection” section.