Installation Guide

Table Of Contents

PAGE 1
PREMIER 1.MARK DOOR A. Start approximately 36"from floor Fold and apply template to high edge of door bevel and mark center of door HIGH SIZE edge as indicated OF BEVEL ARK FOR 1° HOLE IN DOOR EDGE 2.DRILL HOLES A.Drill 2°or hole through door face as marked for locket it is recombination dad that holes ba drifted from both sides to prevent splitting. a 2° HOLE JAN STALL LATCH A. Insert latch in hole keeping it parietal to face of door. Mark outline and remove latch.
PAGE 2
PAGE 3
(PREMIER INSTRUCTIONS FOR HOW TO USE THE ADJUSTABLE LATCH . The latch is factory preset at (backstreet, which is standard for most doors. . To use the (backstreet, no adjustment is required, simply insert the screw stems on the outside knobs thru holes (A) and (C) of the latch and proceed with installation of locket . To adjust latch to position, hold rear of latch and rotate latch case 1/2 turn pulling front of latch forward until pin snaps into the position. .
PAGE 4
PREMIER INSTRUCTIONS FOR INSTALLATION OF LOCK SINGLE AND DOUBLE CYLINDER DEADLOCKS FOR USE ON DOORS TO (35mm-45mm) I.MARK DOOR A Fold and apply template to high edge of door navel and mark center of door doe as indicated on : template at the desired height from the floor A Drill thru door face as marked for locket: it Is recommended that holes be drilled from both sides to prevent spiting Hole size is 27 {80 8mm for standard installations. A. Insert latch in hole keeping it parallel to face of door.