MOTOR TREND® Bluetooth® Headset User Guide Noise Cancelling Technology ITEM# MT-5000 PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.com.
Index 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27.
1. Notice before Using Thank you for purchasing the MOTOR TREND® Bluetooth® Headset MT-5000. Please check the contents of this package to verify the items listed in the Package Contents List below to has been included in your package. Be sure and read this User Guide before you use the Headset.
NOTE: Before using the Headset for the first time, be sure and fully charge the unit at least 3 hours. 4. Charging the Headset The MT-5000 comes with a built in Lithium Polymer battery. To charge the unit: a. Plug the travel charger into an electrical outlet or plug the car charger into cigar lighter.. b. Plug the unit end of the Travel Charger or car charger into the Power Interface Adapter on the Headset. c. While charging, the LED Indicator Light will turn red.
. Power On / Off a. Push the ON/OFF button to ON side. The power will turn on after the LED Indicator Light flashes the blue light 3 times. b. Push the ON/OFF button to OFF side. The power will turn off after the LED Indicator Light flashes the blue light 1 time. NOTE: ·While the Headset is turned on, it will automatically search for the paired device.
c. Should one of the following occur, the paired devices should remain paired: 1. The power for or of the devices is off. 2. The service or one of the devices is off. 3. One of the devices is re-switched on. 7. Pairing to 2 devices This headset contains a dual-link function for connecting with 2 mobile phones simultaneously. a. Pair the first phone following the steps above. b. Turn off the headset c.
Motorola. 10. Refusing Calls To refuse a call, wait to hear from our receiver, and then press the VOL+ 2 twice quickly to refuse the call. If you have the mobile device set to automatically answer calls, refusing call as described here will not apply. 11. Ending Calls a. When the call is complete, press the Function button to end the call. b. You can also wait until your caller hangs up and the call will be disconnected automatically. 12. Voice Dialing a.
NOTE: To activate this function, your mobile device must support the Handsfree mode. For more details, please check your mobile device’s manufacturer’s instructions for additional information. 16. Adjusting the Volume During a call, you may adjust the Headset’s volume. a. To increase the volume, press the Increase Volume Key (+). b. To decrease the volume, press the Decrease Volume Key (-). NOTE: You will hear the “Du Du” sound while adjusting the volume to the highest and lowest settings. 17.
Operation Temperature Facility Saving Temperature Operation Moisture -10 ~ 55℃ -20 ~ 60℃ 10% ~ 90%(non-concrete status) 20. Diagnosing Problems a. If the Headset LED Indicator Light is flashing red-the battery is low and recharges the unit immediately. b. If, after recharging for 20 minutes, the Headset does not turn on: For initial use, the power will be on after charging the Headset at least 40 minutes.
1. The Car Charger is designed for car use only. 2. Connect the Car Charger with the appropriate power supply. 3. Do not unplug the Car Charger from the electrical outlet by the cord 24. BATTERY 1. New battery: For first time use, charge the battery at least 4 hours, preferably overnight (8-10 hours). 2. Only manufacturer authorized personnel can perform battery replacement. 3. Under normal usage, the built in battery should be viable for up to 24 months or longer depending on usage. 。 4.
Q: Must I pair the Headset every time I use it? A: No. The paired devices should remain paired regardless of turning the power off, reopening the devices or charging the respective devices’ batteries. Q: Why is the voice from the Headset not clear? A: Possibly for one or both of the following reasons: 1. Your location has an insufficient signal. You must move to a better signal area or location. 2. The working range between the Headset and the mobile phone has been exceeded.
Obtaining Original Warranty Service To return the Bluetooth® Product(s) to Premier Accessory Group, LLC for Warranty Service, you must include: -The original receipt or copy of the receipt for proof of purchase. -All the headset including any charger that came as original to the headset. -If less than 7 days from purchase, please return the original packaging. -Provide information regarding the nature of the problem and reason for return. -Provide your name, address and telephone number.
FCC ID: ZJVMT-5000 IMPORTANT REGULATORY INFORMATION This device complies with Part 15 of the FCC Rules: Operation is subject to the following two conditions: 1. This device may not cause harmful interference and 2. This device must accept any interference that is received, including any interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
