TPM3 for 3 Kaneka Modules Assembly Instructions

First, install the short set of Module Rails at the northern end of the Strongback
A. Align the short Module Rail mounting holes with the holes of the Mounting
Angle and secure with 3/8" x 1" bolts and hardware. Finger-tighten for now.
(See Figure 3-3)
B. Continue in this manner and install the remaining short Module Rail.
Module Rail Set
(supports
one Module)
Mounting
Angle
Flat Washer
Lock Washer
Flat Washer
3/8" Nut
3/8" x 1" Bolt
S
W
E
N
Figure 3-3: Installing the Short Set of Module Rails
Next, install the long set of Module Rails at the southern end of the Strongback
A. Align the first long Module Rail mounting holes with the holes of the
Mounting Angle and secure with 3/8" x 1" bolts and hardware. Finger-
tighten for now. (See Figure 3-4)
B. Continue in this manner and install the remaining long Module Rail.
NOTE:
Finger-tighten the
Module Rails to
the Strongback
while installing.
After PV Modules
are installed,
re-tighten to
specified torque
values.
Assembly Instructions, Top-of-Pole Mount (TPM3) One over Two (Version 1, Rev A) 7 of 10