TPM3 for 3 Kaneka Modules Assembly Instructions

C.
Support Bar hardware, the Pivot Bolt must be re-tightened. The Pivot Bolt
cannot be left loose - the Mounting Sleeve Vertical Towers must be firmly
clamped to the sides of the Strongback eliminating any gaps between the
Vertical Towers and the Strongback. Torque to 125-150 ft.-lbs. (See Figure
6-3)
Re-tighten the Pivot Bolt. After changing the tilt angle and tightening the
Figure 6-3: Tighten and Torque the Pivot Bolt
Strongback
Towers
No Gaps
No Gaps
Pivot
Bolt
Strongback
Towers
Visible
Gaps
Visible
Gaps
Pivot
Bolt
WRONG
CORRECT
Pivot Bolt must be t
becomes difficult to impossible and it definitely must not move freely.
ightened enough that moving the Strongback
10 of 10 Assembly Instructions, Top-of-Pole Mount (TPM3) One over Two (Version 1, Rev A)