TPM3 for 3 Kaneka Modules Assembly Instructions

Table Of Contents

First, install the short set of Module Rails at the northern end of the Strongback

A. Align the short Module Rail mounting holes with the holes of the Mounting

Angle and secure with 3/8" x 1" bolts and hardware. Finger-tighten for now.

(See Figure 3-3)

B. Continue in this manner and install the remaining short Module Rail.

Module Rail Set

(supports

one Module)

Mounting

Angle

Flat Washer

Lock Washer

Flat Washer

3/8" Nut

3/8" x 1" Bolt

Figure 3-3: Installing the Short Set of Module Rails

Next, install the long set of Module Rails at the southern end of the Strongback

A. Align the first long Module Rail mounting holes with the holes of the

Mounting Angle and secure with 3/8" x 1" bolts and hardware. Finger-

tighten for now. (See Figure 3-4)

B. Continue in this manner and install the remaining long Module Rail.

NOTE:

Finger-tighten the

Module Rails to

the Strongback

while installing.

After PV Modules

are installed,

re-tighten to

specified torque

values.

Assembly Instructions, Top-of-Pole Mount (TPM3) One over Two (Version 1, Rev A) 7 of 10