TPM3 for 3 Kaneka Modules Assembly Instructions
Step 1: Install the Mounting Sleeve on Vertical Pipe
Before installing the Mounting Sleeve, verify that the Mounting Pole is plumb to
the ground and hasn't shifted or leaned while the concrete footing has cured.
The Mounting Sleeve slips on top of the Mounting Pole and has three 3/8" Set Bolts
which are used to secure it to the Mounting Pole. (See Figure 1-1)
A. Slip the Mounting Sleeve on top of Mounting Pole and slide it down until it
rests/bottoms out on top of Mounting Pole.
B. Rotate the Mounting Sleeve so the Support Bar Pivot Tab is pointing north
and the Strongback Vertical Towers are leaning south.
C. Secure the Mounting Sleeve by tightening the three 3/8" Set Bolts. Torque
each Set Bolt to 32-34 ft.-lbs.
Step 2: Install the Strongback to the Mounting Sleeve
The Strongback is attached to the Mounting Sleeve using the Pivot Bolt that passes
through its two Vertical Towers and the Support Bar. The Support Bar is attached to
the Strongback on one end and the Support Bar Pivot Tab of the Mounting Sleeve
on the other end using 3/8" hardware.
A. Remove the Support Bar from the Strongback and re-install in the 15°
elevation set point. Secure with the 3/8" hardware and finger tighten. (See
Figure 2-1)
Elevation Set Points
Strongback
Support
Bar
15° Position
65°55° 45° 35° 25° 15°
N
E
W
S
Mounting
Sleeve
Strongback
Vertical Towers
Leaning
South
Support Bar
Pivot Tab
pointing
North
Mounting
Pole
Set Bolts
Figure 1-1: Installing the Mounting Sleeve
Figure 2-1: Positioning Support Bar
CAUTION:
Use care while
working around
the structure
during assembly.
There could be
components that
create hazards or
obstruct free
movement causing
serious bodily
injury. Many are at
head/eye level.
Move slowly and
with care around
the work area.
NOTE:
Although this
system offers six
elevation set
points, for ease of
assembly, set the
angle to its lowest
setting of
15-degrees.
Optimum tilt
setting of the rack
will take place
later in these
instructions.
Assembly Instructions, Top-of-Pole Mount (TPM3) One over Two (Version 1, Rev A) 3 of 10