MPM-G2 Assembly Instructions

60% of Module
Length between
Rail Brackets
60% of Module
Length between
Rail Brackets
1/2"
Center
(Run of Horizontal Tube)
20%20%
Module Length
ModuleModule
Figure 4-3: Establishing Position and Spacing of Rail Set Assemblies - for an install
with an Even number of Rail Sets
Figure 4-2: Establishing Position and Spacing of Rail Set Assemblies - for an install
with an Odd number of Rail Sets
60% of Module
Length between
Rail Brackets
1/2"
20%
Center
(Run of Horizontal Tube)
20%20% 20%
Module Length
Module ModuleModule
How to work around the Pipe Caps
There will likely be situations where the placement of the Rail Set Assembly (using
the guidelines above) is such that the assembly lands too close to or on top of a Pipe
Cap/Top Plate in such a manner as to prevent the assembly from being properly
installed. If this occurs, the Rail Set Assembly must be repositioned in order to
avoid the Pipe Cap and allow proper attachment of the assembly to the Horizontal
Pipe. If repositioning is required, it must be done in such a way that the Rail Set
Assembly is repositioned as close as is possible to the Pipe Cap while still allowing
for proper attachment to the Horizontal Tube. (See Figure 4-4)
8 of 15 Assembly Instructions, Multi-Pole Mount - G2 (Version 1, Rev D)