MPM-G2 Assembly Instructions

Installing Modules using Standard End
and Mid Clamps:
Start with exterior Module and End Clamps.
A. Place Module on two Power Rails,
centering it lengthwise. Use a
square to square-up the Module to
the Power Rails.
B. Insert one 5/16” x 2, 2-1/4, 2-1/2 or
2-3/4” carriage bolt into the top
slot of the Power Rail. Push the
bolt against the side of the module
frame. Install End Clamp onto bolt
and secure with 5/16" flange nut.
Torque to 14-16 ft.-lbs. (See
Figures 5-1 and 5-3)
Figure 5-2: Correct and Wrong methods of installing a Mid Clamp
WRONG
Installed with
Modules butted
against Mid
Clamp Tabs
Module Frames
Tabs
Mid Clamp
is not square
to Modules
Visible Gaps
between Mid
Clamp Tabs and
Modules
CORRECT
P14 Power Rail
Standard
End Clamp
5/16 x 2, 2-1/4, 2-1/2, or 2-3/4 inch bolt.
Length dependent on Module frame depth.
**
5/16”
Flange
Nut
5/16” x
Carriage Bolt
**
Figure 5-3: Installing Modules using
Standard Hardware End-Clamp
Assembly Instructions, Multi-Pole Mount - G2 (Version 1, Rev D) 11 of 15