Users Manual Part 1

center pin in the connector has positive current. Reversing the polarity on the connector will not
damage the DataHub but it will prevent it from powering on.
You will notice a blue status LED on the top of the unit illuminates when the unit is correctly
powered on.
Accessing the Web User Interface
Once powered on the DataHub needs to be configured to select the GPS data source,
establish an Internet connection, to enable and set the tracking interval, and to password secure
it’s WiFi.
Before you can start the configuration process you must first establish a connection either via
Ethernet or WiFi to login to its web administrative interface.
The DataHub web interface is mobile friendly and supports all popular web browsers.
Access via WiFi
The DataHub advertises itself via WiFi with an SSID “PW-Hub-XXXX” where XXXX is an
alphanumeric sequence specific to the device. By default the DataHub WiFi is unprotected.
As part of the configuration process you may change the SSID of the unit and encrypt and
password protect the unit. Procedures for assigning a password are discussed later on in the
“Securing DataHub” section of this document.
To WiFi connect to the DataHub scan for available access point SSIDs and select the one that
corresponds to your unit. The following image depicts the process for Mac OS X. Other OS’s
use a similar process.