Owner's Manual

Page 3For technical questions, please call 1-888-866-5797.Item 68531
Installing the Feet
1. Secure the Foot (18)
onto the bottom of
the Foot Support (16)
with a Bolt (19)
and Nut (15).
2. Working on the opposite end of the Frame from the
wheels, align the holes in
the frame with a Foot
Support (16) and secure in
place with two Bolts (17)
and Nuts (15). Repeat with
the other Foot support.
Installing the Handle
1. Remove the bolt holding
the Handle (12) to the
Handle Seat (7) before
installing the Handle Seat.
2. Holding the Handle
Seat as shown at right,
align the holes of the
Handle Seat (7) with the
holes on the generator
frame on the same
side as the Feet.
3. Secure in place with
the four Bolts (8, 9)
and Nuts (14).
4. Align the Handle (12) with the holes in the Handle
Seat and secure in place with the Bolt (11)
and Nut (10).
5. Use the Pin (22) to
secure the handle in
the raised or lowered
position.
Maintenance
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
1. BEFORE EACH USE, inspect the general condition
of the wheels and hardware. Check for loose
parts, misalignment or binding of moving parts,
cracked or broken parts, and any other condition
that may affect safe operation of assembly.
2. AFTER USE, wipe external
surfaces with a clean cloth.
15
16
18
19
Figure 3
15
16
17
Figure 4
14
7
9
11
10
Figure 5
Figure 6
Figure 7
11
12
10
Figure 8
To lock
raised
To lock
lowered