Owner's Manual

Page 9O&(%$*4.8"4,7%R'*#$"&8#N%/7*,#*%4,77%ST<<<T<UUT;>V>1ITEM 58057
JAO6IFJ6I?WDBJIAEEAIDGBHADBI6BAB@6
,QVWDOO([KDXVW3LSH௘௘0XIIOHU$VVHPEO\&DUEXUHWRU௘௘,QWDNH0DQLIROG$LU)LOWHUG"7%Z(*,$.*(%I'+*
1. Install Exhaust Pipe Gasket onto exhaust port
studs. Attach the Exhaust Pipe to the studs
using two Spring Washers and two M8 Nuts.
2. Install two Support Bracket Clamps onto Exhaust
Pipe, and position T-bar portion of the Muffler
Support Bracket between Clamps. Partially
tighten Clamps to hold Bracket in place.
Mount the Bracket onto the engine using one
5/16-24 Bolt. Finger tighten Bolt, tighten Clamps,
then tighten Bolt securely. Refer to Figure A
for the Support Bracket mounting location.
3. Attach the Muffler to the Exhaust
Pipe with the Muffler Clamp.
4. Attach the Carburetor to the Intake
Manifold using two M6 x 16 Bolts.
5. Install Intake Manifold Paper Gasket onto
intake port studs. Attach the Carburetor / Intake
Manifold Assembly to the studs using two
M6 Nuts. Route Carburetor drain hose to
safe drain area and avoid heat and abrasion.
6. Attach the Air Filter to the Carburetor
inlet using the Air Filter Clamp.
7. Insert one end of the Oil Breather Tube into the
hole on the Valve Cover. Route other end of Tube
to an overflow can (not included). If necessary,
attach an extension tube (not included) to the end
of the Oil Breather Tube to reach the overflow can.
B&$*- Ensure that oil breather flow is
not restricted by tubing or overflow can,
which must be vented to atmosphere.
&DUEXUHWRU௘
D8$,a*%
H,8"2&79%
A##*5+7L
G"7%
Z(*,$.*(%
I'+*
A"(%O"7$*(%@7,5/ A"(%O"7$*(
;0SUTij%
Z&7$
0௘[%ROW
H<%B'$
HU%B'$
H'227*(
H'227*(%@7,5/
6K.,'#$%W"/*%
Y,#a*$
D8$,a*%
Y,#a*$
D8$,a*%H,8"2&79
6K.,'#$%
W"/*
J/("83%
X,#.*(
@,(+'(*$&(
H'227*(%%
J'//&($%Z(,4a*$
!"*)%2(&5%$.*%I&/
O"3'(*%Z
P(,"8%
[&#*
GTM"83
J'//&($%%
Z(,4a*$%@7,5/#