Owner's Manual

Page 10 O&(%$*4.8"4,7%R'*#$"&8#N%/7*,#*%4,77%ST<<<T<UUT;>V>1 ITEM 58057
JAO6IF J6I?W DBJIAEEAIDGB HADBI6BAB@6
,QVWDOO)XHO)LOWHU௘௘)XHO/LQHV
There are three tubes that attach to the Fuel Pump:
a. Inlet fuel line from fuel tank (tank not included) to Fuel Filter, then to Fuel Pump.
b. Outlet fuel line to Carburetor.
c. Low pressure pulse tube that is attached to the Pulse Connector on the Crankcase Cover Assembly.
When installing ensure that these tubes are routed to avoid heat and sharp edges.
1. Using Fuel Line Clamps, attach appropriate
lengths of fuel line from the fuel tank to
the Fuel Filter, then from the Fuel Filter to
the IN connector on the Fuel Pump.
2. Attach an outlet fuel line from the OUT
connector on the Fuel Pump to the fuel inlet
on the Carburetor using Fuel Line Clamps.
3. Connect an appropriate length of fuel
line between the “P” port on the Fuel
Pump and the Pulse Connector on the
engine using Fuel Line Clamps.
O'*7%I,8a
d2'*7%$,8a%5'#$%
+*%Q*8$*9e
@,(+'(*$&(
W'7#*%
@&88*4$&(
E&)%W(*##'(*%
W'7#*%I'+*
O'*7%
W'5/
O'*7%
O"7$*(
O'*7%E"8*%@7,5/
d'#*9%&8%*Q*(L%2'*7%
7"8*%4&88*4$"&8e
G'$7*$%
O'*7%E"8*
D87*$%
O'*7%E"8*