User's Manual

PBS installation guide

PBS channel

indicator #1

RF antenna

connector #1

TCP/IP port #1

Installation:

1. Connect the PBS to the power supply. Verify that the power indicator LED (#1) turns

on.

 Warning: The power consumption of the unit is 12V-2.0A,. In order to

ensure proper functioning of the unit, use the power source supplied with the

unit or a compatible power unit with the same polarity and voltage.

2. Connect the antenna to the appropriate RF Channel

antenna connector. You can use only antennae supplied

by Precyse technologies. Other antenna types are not

supported. Verify that the appropriate PBS channel

indicator LED flashes.

3. Connect the PBS IP port to the server using the

appropriate IP port on the PBS unit. The Ethernet LED on

the connector will light indicating the connectivity.

 Note: The PBS unit has 4 holes in the base for fixing the unit in place. Use 4 screws

and washers to fasten the unit. DO NOT DRILL HOLES IN THE UNIT OR OTHERWISE

CHANGE THE PROTECTIVE BOX OF THE PBS.

4. Amplifier unit: If such unit is used, connect it according to the following block

diagram. Use only cables and connectors approved by Precyse Technologies.