Installation Guide
PBS installation guide
Parelec Inc.
10
Checking the installation
Visual check after connection
Verify that the power LED indicator (red) is on when the power is connected.
Verify that the appropriate PBS RF Channel indicator is on.
Verify that the Appropriate LAN LED indicator is on
Check connection of PBS to the network / server ( ping ) .
Appendix A: Marketing and installation
1. The product intended use and application:
The BS24103000 (PBS) is used as a radio base station for the iLocate system.
By transmitting a synchronization signal, and receiving transmissions from other
devices on the iLocate network it acts as a bridge between the iLocate hardware
and a personal computer.
2. The EUT is installed either indoors or outdoors (inside an appropriate sealed
box).
The installation requirements are proper site planning, infrastructure (AC supply
with an AC to DC adapter or DC supply, mechanical mounting, clearance around
it), sealed box (Per Precyse Tech’s requirements, an IP55 or equivalent box
uninterrupted power supply where required, etc).
3. Amplifier unit: Use only the supplied amplifier unit with its supplied base station.
Use only the supplied cables which were shipped with the unit. In case of
damage or fault, use only authorized replacements from Precyse Technologies
Inc.
4. Marketing:
The EUT is sold to system integrators only. It is not available for non-
professionals.