Owner`s manual

Opeartion and Maintenance Guide: Initial Search for Channels 7
Automatic Search with a Remote
Control
If you have a remote control, follow these steps to automatically
search for the available channels on the PVS screen. While you are
in the Video Setup menu, if you do not press a button or complete a
sequence within 15 seconds, the Video Setup menu disappears and
the PVS screen will return to normal viewing mode.
1. Turn on the PVS screen.
2. Press the Menu button on the remote control. The Video Setup
menu appears on the PVS screen.
3. Use the Channel – button to move down to TV Install.
4. Press the SEL button to select TV Install.
5. Press the SEL button again to select Auto Search, which is
already highlighted.
6. Select the appropriate mode for the input you plan to use by
pressing the Channel buttons to move to that mode and pressing
the SEL button. Typically, you will choose the Cable TV mode.
The screen shows the message “Scanning XX STOP: Menu
key.” The XX changes as the automatic programming feature
scans the available channels. This process may take several
minutes to finish. When done, the lowest programmed channel
appears on the screen.
Note: You can stop the automatic programming process at any
time by pressing the Menu button.