Owner`s manual

Opeartion and Maintenance Guide: Initial Search for Channels 6
Initial Search for Channels
After you install the PVS hardware and all power and cable or
antenna connections are completed, turn on each individual PVS
screen and run the automatic search feature. This feature identifies
the TV channels that are available. After the feature runs, the PVS
screen displays only those channels that are available.
This section provides instructions for running the automatic search
feature using either the integrated controller or the remote control.
Automatic Search with the Integrated
Controller
Follow these steps to automatically search for the available channels
on the PVS screen using the integrated controller. While you are in
the Video Setup menu, if you do not press a button or complete a
sequence within 15 seconds, the Video Setup menu disappears and
the PVS screen will return to normal viewing mode.
1. Turn on the PVS screen.
2. Press both the Volume ▼ and Channel ▼ buttons simultaneously
until the green LED begins flashing (about 5 seconds).
The flashing LED indicates that the PVS screen has entered the
Video Setup mode. The Video Setup menu appears on the PVS
screen.
3. Use the Channel ▼ button to move down to TV Install.
4. Press the Power button to select TV Install.
5. Press the Power button again to select Auto Search, which is
already highlighted.
6. Select the appropriate mode for the input you plan to use by
pressing the Channel buttons to move to that mode and then
pressing the Power button. Typically, you will choose the Cable
TV mode.
The screen shows the message “Scanning XX STOP: Menu
key.” The XX changes as the automatic programming feature
scans the available channels. This process may take several
minutes to finish. When done, the lowest programmed channel
appears on the screen.
Note: Ignore the “STOP: Menu key” message. You will not be
able to stop the automatic programming process because the
integrated controller does not have a Menu button.