Owner`s manual

Opeartion and Maintenance Guide: Maintenance and Troubleshooting 13
Maintenance and Troubleshooting
In general, the PVS screen and integrated controller require little
maintenance and will rarely experience problems once installed.
However, you may find the cleaning and troubleshooting information
in this section useful.
This section also explains how to replace the headphone jack when
it no longer provides good audio quality.
Cleaning the PVS
For the Precor exercise equipment, follow the daily cleaning
instructions and cautionary statements found in the Product
Owner’s Manual.
Periodically dust the PVS screen with a soft clean cloth.
CAUTION: Do not use liquid cleaners or aerosol cleaners to
clean the screen. Do not use any solvents such as alcohol and
paint thinner, or acidic cleaners.
Each week, clean the integrated controller with a mild soap and
water solution. Lightly dampen a soft clean cloth with the solution
and wipe the controller. Do not use too much solution on the cloth or
spray cleaning solution directly on controllers. Doing so could cause
moisture to enter through the connector and damage the controller.
Troubleshooting the PVS
Table 5 may help you to understand and troubleshoot any problems
that you encounter with the PVS screen and integrated controller. If
the suggestions in the table do not help you solve the problems that
you encounter, please contact Cardio Theater Technical Support.
Table 5: How to solve most problems
What to Do
No power Check green LED is lit. Make sure that the power
cable connections are secure and the power cable is
connected to a functioning outlet. Push the Power
button.
No Closed
Captioning
Make sure Caption is On under the Caption feature in
the Video Setup menu. Closed Captioning may not be
available on that channel; try a different channel.
Closed
captioning is
delayed
A delay between captioning and the actual dialogue is
common in live broadcasts.
Screen turns
itself off
Automatic Power On/Off feature may be enabled. The
screen will turn off when headphones are not plugged
into the headphone jack. Refer to Automatic Power
On/Off Setup.
No picture Make sure the correct TV System has been specified
from the TV Install menu (in Video Setup menu). Make
sure PVS screen is fully plugged into a power outlet.
Push the Power button. Try a new channel; it may be
station trouble. Turn the PVS screen off, and then turn
it back on after one minute.
No audio The PVS is designed to automatically decrease the
audio after each person uses it. Increase the audio
level with the Volume ▲ button. Check the headphone
jack. Replace the headphone jack if necessary.
Poor picture Adjust controls such as Brightness, Hue, and
Sharpness under the Picture menu (in Video Setup
menu).
Bars on
screen
Try a new channel; it may be station trouble. Make sure
video cable is connected to connector on the back of
the PVS screen. Check for local interference.