User manual

Assembling the Climber 15
Required Tools
Before beginning the installation, make sure you have the
following tools available:
 Wire tie cutter
 Phillips screwdriver
 One ¹₂-inch combination wrench (open-end or box-end)
 SAE Standard socket set
 Standard set of hex keys
Assembling the Climber
A fish tape (a thin metal strip with a hook or clasp on one end,
available from professional hardware vendors) can be helpful
during this procedure.
To assemble the main climber mechanism:
1. Place the upright support on a flat work surface.
2. Remove the two hex nuts and washers that secure the
handrail clamp, then set them aside.
Figure 2: Removing handrail clamp nuts
3. While your assistant holds the heart rate handlebar near
the display console, feed the heart rate cable through the
opening in the upright support. Pull the end of the cable
out through the top of the support and pass it through the
opening in the console mount as shown in the following
illustration. Place excess cable inside the upright support.
Important: Do not stretch, crimp, or damage the cables.
Cables damaged by improper installation will not be covered
by the Precor Limited Warranty.