Operation Manual

Assembling the EFX 23
Assembling the EFX
DANGER
Do not attempt to connect electrical power until
all assembly procedures are complete and the
console is properly installed.
Assemble the EFX in the order presented. Once you have
assembled it, clean the ramp with a soft cloth dampened in a
diluted solution of mild soap and water.
To begin assembly:
1. Feed the cable through the right upright support. Tape the
cable to the top of the upright support to secure it
temporarily.
Important: Do not stretch, crimp, or damage the cable.
Cables damaged by improper installation will not be
covered by the Precor Limited Warranty.
Figure 2: Feed cable through right upright support