Operation Manual

Biceps Curl Assembly Guide: Assembling the Equipment 12
Connecting the Belt
Note: Before you begin this procedure, make sure that the movement arm is all
the way down.
To connect the belt:
1. Remove the ties holding the rolled-up belt in place on the weight arm.
2. Unroll the belt and route it over the top of the cam as shown in the
following figure.
Figure 10: Belt and retaining block positioning
3. Thread the belt through the retaining bracket on the cam.
4. Insert the retaining block into the retaining bracket, making sure the belt
passes around it on the inward side (the side opposite the two screw
holes).
5. Attach two M8 x 25 mm socket head cap screws to the retaining bracket.
6. Tension the belt so that it has no slack, but still allows the weight arm to
rest on its stop.
7. Tighten the two M8 x 25 mm socket head cap screws as far as possible.
8. Test the operation of the movement and weight arms. If the weight arm
does not come to rest, or if there is too much play in the movement arm,
loosen the two M8 x 25 mm socket head cap screws and reposition the
belt.
9. Tuck the end of the belt into the slot below the retaining bracket.