Operation Manual

Biceps Curl Assembly Guide: Assembling the Equipment 8
Installing the Movement Arm Support
Assembly on the Base Frame
Unlike most Discovery Plate Loaded equipment, the Biceps Curl is shipped
with the movement arm axle preinstalled. The movement arm support
assembly contains the axle, the cam, and the pivot bracket for the weight arm.
To install the movement arm support assembly:
1. Position the assembly over the base frame as shown in the following figure.
Figure 4: Movement arm support assembly positioning
2. Secure the assembly using two M12 x 35 mm socket head cap screws and
two 13 mm flat washers. Partially tighten the fasteners.