Operation Manual

CW-813 Assembly Guide
page 8
Assemble the Unit
1. AttachtheupperBeautybellRacktotheUpright
Frame using
four ¾-inch buttonhead screws (A)
four ½-inch split washers (B)
Loosely tighten the fasteners so the Upright Frame
is stable.
Note: Make sure you attach the rack with the small
Beautybell Holders.
2. AttachthemiddleBeautybellRacktotheUpright
Frame using
four ¾-inch buttonhead screws (A)
four ½-inch split washers (B)
Loosely tighten the fasteners.
3. AttachthelowerBeautybellRacktotheUpright
Frame using
four ¾-inch buttonhead screws (A)
four ½-inch split washers (B)
Wrench tighten all the fasteners.
This completes the assembly of the CW-813.
Clean the Unit
To clean the unit, moisten a clean, soft cloth in a mild
solution of soap and water and wipe all the parts
thoroughly.
Frequently vacuum the floor underneath the CW-813 to
prevent the accumulation of dust and dirt. If necessary,
use the Upright Frame to lift the CW-813.
Assemble the Unit
4 - ¾” buttonhead screws
4 - ½” split washers
4 - ¾” buttonhead screws
4 - ½” split washers
4 - ¾” buttonhead screws
4 - ½” split washers