Instructions / Assembly

6
4. Place a 1” x 1/2” Spacer onto the Axle, followed by a Wheel Bracket. Align the hole of the Wheel
Bracket with the hole in the Axle. Insert a 5/16” x 1-1/2” Hex Head Bolt into the hole in the Wheel
Bracket and Axle. Secure with a 5/16” Nylock Nut. Repeat process on the other side. See Figure 4.
5. Place a 1/2” Flat Washer onto a 1/2” x 3” Hex Head Bolt, followed by a Wheel and then another
1/2” Flat Washer and secure with a 1/2” Jam Nut (Do not over tighten or the Wheel will not turn).
Insert this assembly into the hole in the Wheel Bracket, then secure with a 1/2” Nylock Nut. Repeat
process on the other side. See Figure 5.
Figure 4
Figure 5
Wheel Bracket
1” x 1/2” Spacer
Axle
5/16” x 1-1/2” Hex Head Bolt
5/16” Nylock Nut
1/2” Jam Nut
1/2” Flat Washer
1/2” x 3” Hex
Head Bolt
Wheel Bracket
Wheel
1/2” Nylock Nut
7
6. Align the two holes of the Tow Bar and Handle Brace as shown. Insert a 5/16” x 1” Hex Head Bolt
into one of the holes in the Handle Stop and then through the corresponding hole in the Tow Bar,
place a 5/16” Flat Washer on to the bolt, and secure with a 5/16” Nylock Nut. Repeat process on the
next hole. Insert a 5/16” x 3/4” Hex Head Bolt into one of the two smaller holes on the Clevis Plate
and then into the corresponding hole in the Tow Bar, place a 5/16” Lock Washer onto the bolt and
secure with a 5/16” Hex Head Nut. Repeat process on the next hole. Insert the Clevis Pin through
the larger front hole of the Clevis Plate and through the hole in the Tow Bar and secure with the
Hitch Pin Clip. See Figure 6.
Figure 6
Clevis Pin
Clevis Plate
5/16” Hex
Head Nut
5/16” Flat Washer
5/16” Lock Washer
5/16” x 3/4” Hex
Head Bolt
Handle Brace
5/16” x 1” Hex Head Bolt
5/16” Nylock
Nut
Tow Bar
Hitch Pin Clip