Instructions / Assembly

6
5. Assemble four 5/8” Flat Washers, two Wheels and two 1/8” x 3/4” Cotter Pins. Place one 5/8” Flat
Washer onto the Axle followed by a Wheel, and another 5/8” Flat Washer, insert a 1/8” x 3/4” Cot-
ter Pin into hole in the Axle and spread the legs of the Cotter Pin apart. See Figure 5.
4. Assemble the Boom Angle, two 5/16” x 3/4” Hex Head Bolt, two 5/16” Lock Washers and two
5/16” Hex Head Bolts. Insert the 5/16” x 3/4” Hex Head Bolt through the Boom Angle and then
through the TCT Frame. Attach the 5/16” Lock Washers and secure with 5/16” Hex Head Nuts. See
Figure 4.
Figure 4
5/16” Hex
Head Nut
TCT
Frame
Boom
Angle
5/16”
Lock
Washer
5/16” x 3/4”
Hex Head
Bolt
7
6. Screw Pressure Gauge into 1/4” Tee w/port, turning in a clockwise manner. See Figure 6.
See Figure 5
Axle
1/8” x 3/4” Cotter Pin
5/8” Flat
Washer
Wheel
5/8” Flat
Washer
Pressure Gauge
Figure 6