Instructions / Assembly

8
Figure 5
5. . On the long side of the Axle place a 3/4” Flat Washer followed by an Axle Spring and then another 3/4”
Flat Washer. Followed by a 3/4” Flat Washer an Aerator Star, another 3/4” Flat Washer and a 1” x 3” Spacer.
Repeat the process five more times. See Figure 5.
Axle
Aerator Star
Spring
3/4” Flat Washer
1’ x 3” Spacer
3/4” Flat Washer
Aerator Star
9
Figure 6
6. Insert a 3/4” Axle Bushing into the End Plate and place the Bushing and End Plate onto the Axle. Insert a
5/16” x 3/4” Hex Head Bolt into one of the end holes in the Base Plate. Then insert the bolt into the holes in
the End Plate, place a 5/16” Lock Washer onto the bolt, loosely attach a 5/16” Hex Head Nut onto the bolt at
this time. Repeat this process on the other side. Now alternating back and forth between the two bolts
tighten the nuts. This will slowly increase the tension on the Axle Spring, until this side is tight and properly
aligned.
5/16” x 3/4” Hex
Head Bolt
Axle
5/16” Hex Head Nut
5/16” Lock Washer
End Plate
3/4” Axle Bushing