Instructions / Assembly

10
7. Align the hole of the Wheel Bracket with the hole in the Axle. Insert a 5/16” x 1-1/2” Hex Head Bolt into
the hole in the Wheel Bracket and Axle. Secure with a 5/16” Nylock Nut. Repeat process on the other side.
Place a 1/2” Flat Washer onto a 1/2” x 3” Hex Head Bolt, followed by a Wheel and then another 1/2” Flat
Washer and secure with a 1/2” Jam Nut (Do not over tighten or the Wheel will not turn). Insert this assembly
into the hole in the Wheel Bracket, and secure with a 1/2” Nylock Nut. Repeat the process on the other side.
See Figure 7.
Figure 7
5/16” Nylock Nut
5/16” x 1-1/2”
Hex Head Bolt
Wheel Bracket
1/2” x 3” Hex
Head Bolt
1/2” Flat Washer
Wheel
Axle
1/2” Jam Nut
1/2” Nylock Nut
7
4. Insert a 3/4” Axle Bushing into the End Plate and place the Bushing and End Plate onto the Axle. Insert a
5/16” x 3/4” Hex Head Bolt into one of the end holes in the Base Plate. Then insert the bolt into the holes in
the End Plate, place a 5/16” Lock Washer onto the bolt, loosely attach a 5/16” Hex Head Nut onto the bolt at
this time. Repeat this process on the other side. Now alternating back and forth between the two bolts
tighten the nuts. This will slowly increase the tension on the Axle Spring, until this side is tight and properly
aligned. See Figure 4.
Figure 4
5/16” x 3/4” Hex Head
Bolt
5/16” Hex Head Nut
5/16” Lock Washer
End Plate
3/4” Axle Bushing
Axle