User's Manual
OFF
ON
Using a small piece of wire or paper clip, push the learn link button on the back of the receiver.30.
When a mutual frequency has been found, the receiver will beep twice. If a mutual frequency was 31.
repeat the procedure. If a problem still persists, check the system installation.
OPERATION
While driving in reverse, a beep will sound and a green LED will light up when an object is 5 feet 1.
(1.5 m) away. If the object is more than 5 feet (1.5 m) away, there will be no sound and the LED will
not light up.
As you get closer to an object, the beeping speed will increase and additional LED lights will light 2.
up.
When all LEDs are lit and the alarm is a constant sound, stop the vehicle
immediately. Continuing in reverse may damage vehicle or back-up sensors.
3.
beep will be a constant sound.
The volume can be adjusted using the volume control dial on the receiver.4.
Distance Alarm LED Lights
over 5 ft (1.5 m)
No beep No LEDs illuminate
59-47 in. (1.5-1.2 m)
Green LED illuminates
47-39 in. (1.2-1.0 m)
Green LED illuminates
Yellow LED illuminates
Yellow LED illuminates
Constant sound All LEDs illuminate
CARE AND MAINTENANCE
Storage
Store this Back-Up Sensor in a cool, dry area and keep it away from direct sunlight, heat, excessive
humidity and dampness.
Cleaning
Do not clean or wipe the Back-Up Sensor with solvents or chemical materials. If necessary, remove
dirt or stains using a soft cloth dampened with a mild detergent solution.
Disposal
The Back-Up Sensor is designed to provide years of service. The Back-Up Sensor should
be recycled or safely disposed of at a local recycling center. Examples of places that will
dealers.