User's Manual
4
INSTALLATION
Some states or local governments may have regulations or laws that restrict the
use of anything that might impair the clear view of a license plate. Check local laws for
compliance.
For the Back-Up Sensor to be properly installed, it must be wired into the vehicle’s
taillight harness. If you are not comfortable or knowledgeable with 12-volt DC wiring, have
the system professionally installed.
These instructions are only meant as a general guide due to the number of
dierent makes and models of vehicles. For vehicle-specic questions contact your vehicle’s
manufacturer.
Remove the screws that hold the license plate to the vehicle.1.
Position the left and right sensor mounting plates behind the license plate.2.
Insert the screws through the license plate and the sensor mounting plates.3.
Install the screws to secure the sensors to the vehicle.4.
POWER
POWER
RIGHT
LEFT
+
2
3
7
6
8
9
4
3
5
1
Legend
1. Controller
2. Positive (+) Wire from Reverse Light
3. Wire Connector
4. Reverse Light
5. Negative (-) Wire from Reverse Light
7. Positive (+) Controller Power Wire (Red)
9. Left Sensor