Product Manual

4
Assembly Instructions
Tools Needed For Cart Assembly
(2) 5/16” Wrenches
(2) 3/8” Wrenches
(1) Screwdriver
Remove from Carton
Remove all parts and hardware packages from the
carton. Lay out all parts and hardware and identify
them using the illustrations pages 2 and 3.
1. Slide Spring over the Latch Handle as shown in
Figure 1.
2. Slide the 1/4” x 2.75” Spacer through the Spring
and Latch as shown in Figure 2.
1/4” x 2.75”
Spacer
Figure 2
Figure 1
Latch
Spring
3. Slide the Latch, Spring and Spacer through the
Tow Bar. This will cause the Spring to open. See
Figure 3.
4. Slide 1/4” x 3—1/2” Hex Head Bolt through
Spacer and secure with a 1/4” Nylock Nut.
See Figure 4.
5. If assembled correctly the
Latch should be forced toward the back of the Tow
Bar by the spring.
Figure 1
Figure 3
Spring
Top of Tow Bar
Latch
Pedestal Tab
1/4” x 3
1/2”
Hex Head
Bolt
1/4” NyLock
Nut
Figure 4
9
11. Slide Axle through Undercarriage and Tow Bar. Center Axle, place one 3/4” Flat Washer, one 1”
x 1” Spacer onto the Axle followed by Wheel, place another 3/4” Flat Washer onto the Axle and se-
cure with a 1/8” x 1-1/4” Cotter Pin. Repeat process on other side. See Figure 10.
Figure 10
Tow Bar
Axle
Wheel
1/8” x 1-1/4”
Cotter Pin
3/4” Flat
Washer
Undercarriage
1” x 1” Spacer