Instructions / Assembly

6
Parts and Support
Please do not return this product to the
store prior to contacting Precision.
At Precision Products, Inc. our goal is to deliver
quality, value and outstanding service. If for any
reason our product does not meet your expecta-
tions, please contact us and we will take care of any
problem you may have with this unit.
When ordering replacement parts please have the
model number, part description, part number, in-
spector number and date on carton available so that
we can best serve you.
1 [phone]
www.precisionprodinc.com
Precision Products Inc.
316 Limit St.
Lincoln IL 62656
STOP
Operation
TO DUMP - Pull Latch toward lawn tractor and
Cart Body will tilt back to dump position.
TO RETURN TO PULLING POSITION - Push
down on front edge of Cart Body until Latch en-
gages and secures to Tow Bar.
Tractor speed should be not exceed 3-4 miles
per hour. The heavier the load, the slower the
speed for safe operation.
Maintenance Instructions
Keeping the cart clean and dry will prolong the
unit’s life.
Grease Wheels at regular intervals, at least once
every six months, more frequently if used regu-
larly.
Should rust develop, sand lightly then paint area
with enamel paint.
Check tire pressure at regular intervals. Proper
inflation will prolong the life of tires (see side of
tire for inflation amount.)
9. Place 3/4” Flat Washer one on each side of Axle
next to Undercarriage. Place Wheel onto Axle, place
another 3/4” Flat Washer on outside of wheel. Repeat
the Wheel attachment step for the other wheel.
Extra 3/4” Flat Washers are included, to be used on
the outside Wheel, if needed as spacers, to insure
minimum clearance between the undercarriage and
Wheels. Secure Wheel in place by inserting Cotter Pin
through hole in the end of Axle and spreading the
legs of the Cotter Pin outward. See Figure 9.
10. Turn Cart to an upright position, then attach Tow
Bar to Hitch of tractor, placing Clevis Pin through
Clevis Plate Hole and securing with Clevis Pin Clip.
Insert 1” x 1” Tube Plugs. See Figure 10.
10
20
3/4 “ Flat Washer
Figure 10
Clevis Pin
Hitch Pin
Clip
Figure 9
Cotter Pin
3/4” Flat
Washer
Cotter Pin
Extra Washer (if needed)
1” x 1” Tube Plug
3
22
Shown Full Size
10 11
17 16
13
15
14
12
20
19 18
21
23 24
25
Ref. Qty. Description
10 2 5/16” x 3/4” Hex Head Bolt
11 4 5/16” x 3/4” Truss Head Bolt
12 12 3/8” x 3/4” Truss Head Bolt
13 1 1/4” x 3-1/2” Hex Head Bolt
14 1 1/2” x 1-3/4” Clevis Pin
15 12 3/8” Lock Washer
16 1 1/4” Reverse Lock Nut
17 6 5/16” Hex Head Nut
18 12 3/8” Hex Head Nut
19 6 5/16” Lock Washer
20 1 #14 Hitch Pin Clip
21 2 1/8” x 1-1/4” Cotter Pin
22 1 Spring
23 6 3/4” Flat Washer
24 2 1” x 1” Tube Plug
25 1 1/4” x 3” Spacer
Hardware sack may contain more parts that needed.