Product Manual

8
10. Insert a 1/4” x 3” Hex Head Bolt into 1/4” Flat Washer, into hole in the top of the body,
through Cross Tube then insert bolts into Handle. Secure with a 1/4” Nylock Nut. See Figure 9.
Figure 9
Cross Tube
Handle
1/4” x 3 Hex Head Bolt
1/4” Flat Washert
1/4” Nylock Nut
5
6. The Leg and Clevis Plate are both attached to the Short Tow Bar, using two 5/16” x 3/4” Truss Head Bolts,
two 5/16” Lock Washers and two 5/16” Hex Head Nuts. Insert 1/2” x 1-3/4” Clevis Pin into the 1st (large
hole) in the Clevis Plate and secure with #14 Hitch Pin Clip. See Figure 5.
7. The Long Tow Bar and the Short Tow Bar are attached by inserting a 1/4” x 3-1/2” Hex Head Bolt
through the second hole from the front on the Long Tow Bar and the last hole on the Short Tow Bar. Secure
with a 1/4” Nylock Nut (Only tighten until nut is touching Tow Bar wall). Insert the 5/16” x 3-1/2”
Clevis Pin into the first hole of the Long Tow Bar and the middle hole of the Short Tow Bar and secure with
the #203 Hitch Pin Clip. See Figure 6.
5/16” x 3/4” Truss Head
Bolt
Clevis Plate
Leg
5/16” x 3/4”
Truss Head
Bolt
Short Tow Bar
1/2” x 1-3/4” Clevis Pin
5/16” Lock
Washer
5/16” Hex
Head Nut
#14 Hitch Pin Clip
5/16” Hex
Head Nut
Figure 5
#203 Hitch Pin
Clip
1/4” Nylock Nut
5/16” x 3-1/2”
Clevis Pin
Long Tow
Bar
Short Tow
Bar
1/4” x 3-1/2”
Hex Head Bolt
Figure 6