User Guide

3
NOTE:
Before beginning, disconnect the negative (-) terminal of the battery
to prevent an electrical short to ground. Reconnect the negative
terminal only after all connections have been made.
Mounting
To prevent damage to the Phase Shifter while driving,
mount it in a secure place. Choosing the appropriate
location will depend upon your vehicle and the complexity of
your system design. Typical mounting locations would be in
the same location as your amplifiers and or crossovers.
Never mount the component in a location that would subject
it to immersion or exposure to water.
Once a location has been chosen, securely mount the
PSC-221 using the four screws supplied. Be Careful!
Inspect the area underneath to be sure you are not drilling
into wires, brake or fuel lines, etc. that could be damaged by
the drill bit or screws.
INSTALLATION / MOUNTING
BACK TO CONTENTS