Installation guide

A
B
C
D
B
A
A
A
C
B
AB
H
h
L
b
B
57ENGINE ACCESSORIES – TRANSMISSION
Clamp attachment
For attaching shaft sleeve.
Part no A, mm Shaft sleeve, mm Shaft Ø, mm
828316 78 42 25
828317 78 48 30
828318 96 54 35
828319 96 60 40
Stern bearing for plastic bonding
Stern bearing with replaceable water-lubricated rubber bearing. Ribbed
surface for secure bonding.
56 ENGINE ACCESSORIES – TRANSMISSION
Part no A, mm B, mm Shaft Ø,
mm
Ext. dia. shaft
sleeve mm
1)
828254 36 66 25 42
828422 36 72 30 48
828526 36 82 35 54
828527 36 82 40 60
3819722 36 92 45 64
3819723 36 92 50 70
3819724 36 66 1" 1 3/4"
3819725 36 75 1 1/4" 2"
3819726 36 82 1 1/2" 2 1/4"
3819727 36 92 1 3/4" 2 1/2"
3819728 36 92 2" 2 3/4"
Rubber bearing
Water-lubricated rubber bearing for stern and support bearings.
Part no A, mm B, mm Shaft Ø, mm
812914 100 38 25
812916 127 44 30
827175 140 48 35
828131 160 54 40
Stern bearing for bolting
Stern bearing for bolting into wooden or fibre glass hulls. Replaceable
water-lubricated rubber bearing. Attached with M8 bolts.
Part no A, mm B, mm C, mm D, mm Shaft Ø,
mm
827780 113 52 96 65 25
827781 140 58 100 73 30
827782 154 66 108 77 35
828162 154 70 118 80 40
828188 180 74 126 88 45
Key for older shafts
A new key is now available for older types of shaft with a 10 mm key
slot to make them suitable for new ISO standard bronze propellers.
Part no b,
mm
B,
mm
h,
mm
H,
mm
L,
mm
Shaft Ø,
mm
3580804 8 10 3.5+0.1 6+0.1 58 30
3580805 10 12 3+0.1 6+0.1 80 40
Lock washer for propeller shaft nuts
Note: V9338 = Week 38, year 1993.
Part no Shaft Ø, mm
873475 25 a)
828383 25, 30 b)
873488 30 a)
a) Lock washer for propeller shafts manufactured after V9338.
b) Lock washer for propeller shafts manufactured before V9338.
Rubber packing box
Moulded packing box for effective lubrication/sealing. Simple, time
saving installation and compact size. Minimal maintenance work
– grease every 200 hours or once a year. The packing box is
specifically dimensioned for Volvo Penta propeller shafts and sleeves.
For effective lubrication it is essential that the packing box bearings
are water-lubricated at all speeds. Supplied complete with installation
tools and grease tube.
1) Diameter tolerance +0.5 –0.3 mm. The distance between bearing
points must not exceed 1500 mm.
Part no A, mm B, mm C, mm Shaft Ø, mm
827885 56 52 120 25
827886 64 60 155 30
827887 70 66 168 35