Installation guide
1
2
3
4
1
2
3
4140 ENGINE ACCESSORIES – EXHAUST ENGINE ACCESSORIES – CHEMICALS
CHeMICAls
Leisure craft engines are often subject to greater wear  
than other engines. The reason is simple: Leisure craft are 
frequently run intensively for short periods and then laid  
up for long periods. It is therefore especially important to 
chose the correct oil, coolant and grease for marine appli-
cations. Not just for economic reasons but also to ensure 
safety at sea.
Exhaust cover kit
In order to comply with strict regional noise limitation requirements, 
Volvo Penta has developed exhaust cover kits for shields and drives. 
The kits are intended for 3.0 and 4.3 petrol engines with SX drive.
Exhaust cover for shield
Note! Delivered as standard in later versions of 3.0 GS/SX.
Includes: Spacer, cover, screws. 
Anode is also needed (not part of the kit).
Part no
3858758
Exhaust cover for drive
Note! To be used only in combination with exhaust cover kit for shield, 
3858758.
Includes: Exhaust port, rivets (2 per side), exhaust cover (1 per side).
Part no
3856171
Exhaust block-off kit
The standard exhaust fitting for I/O-engines leads the exhaust through 
the drive. If a separate silencer is required, then the exhaust port in the 
transom shield must be sealed.
Includes: Cover plate, fittings.
Part no Drive
3850889 SX/DP-S
Exhaust riser
An exhaust riser raises the level of the exhaust elbow. This is installed 
on vessels with engine installations at or below the water line. The riser 
reduces the risk of siphonage back into the engine via the exhaust 
system.
Part no Height
3884165 100 mm/4"
40005141 150 mm/6"
40005142 150 mm/6"
3886142 75 mm/3"
3888846 75 mm/3"
3581031 -
861097 100 mm/4"
861252 90 mm/3.5"
3862907 150 mm/6"
Petrol engine oil
Specially developed for high performance en-
gines. The special properties of this oil allow 
it to lubricate the engine even during low tem-
perature starting. The oil combats sludge build-
up and gives excellent protection against wear. 
Particularly suitable for engines that are subject 
to frequent starting and stopping.
Viscosity: SAE 5W-30
Grade: API SM
Part no Pack Quantity
21363429 Plastic bottle 1 Litre
21363430 Plastic container 5 Litre
21363431 Plastic container 20 Litre
Engine oil
VDS-3 covers even more stringent require-
ments on piston cleanliness and bore polish 
compared to VDS-2, ensuring the durability 
and reliability of the engines. The high quality 
of VDS-3 oils allows in certain cases an  
increase in drain intervals. Fits both diesel and 
gas engines (check operators manual). 
Viscosity: SAE 15W-40 
Grade: VDS-3, API CI-4, ACEA E5
Part no Pack Quantity
3840002 Plastic bottle 1 Litre
3840003 Plastic cont. 5 Litre
3840004 Plastic cont 20 Litre
OILS
Volvo Penta oils are tested together with its application to match and 
interact. The oils contains many protective additives to minimize wear, 
mop up soot, sludge and metallic particles, neutralize acids, trap water 
and have preservative properties. They are also adapted to the special 
demands of low emission engines. 
Volvo Penta oils are therefore the best you can give your engine. They 
ensure lower operating costs through lower fuel consumption. They 
also extend the life of your engine and improve onboard safety. 
Synthetic petrol engine oil
A fully synthetic oil for use all year round.  
Specially developed for high performance en-
gines. Provides excellent protection against 
wear under severe running conditions at both 
high and low extremes of temperatures.
Viscosity: SAE 15W-50/SAE 30
Grade: API SJ, ACEA A3/B3 
Part no Pack Quantity
3809429 Plastic bottle 1 Litre
3809428 Plastic container 5 Litre  a)
a) SAE 15W-50










