Instruction manual

for repair or replacement. Before returning any equipment to the factory, the following
steps should be taken:
1. Notify Electronic Measurement, Inc., Customer Service Department, at telephone
number [phone]. Give full description of the difficulty, including the model
and serial number of the unit in question. Upon receipt of this information, EMI will
assign a Return Material Authorization (RMA) and provide shipping instructions.
2. Equipment returned to EMI must be packed in such a manner as to arrive without
incurring any damage. The shipping container must be marked with the RMA
number in legible numbers near the shipping label. Any returned unit must have its
RMA number clearly displayed on the outside of the container in order to be
accepted.
3. For non-warranty repairs, EMI will submit a cost estimate for the customer’s
approval prior to proceeding.
1.4 SPECIFICATIONS
1.4.1 INPUT CURRENT REQUIREMENTS
105 to 125VAC – or – 210 to 250VAC, 47 to 63Hz. the line is protected by a
circuit breaker located on the front panel rated for all input voltages.
1.4.2 MAXIMUM POWER REQUIREMENTS
200W3A100W100-1
EXCEEDEXCEED100W50-2
NOT TONOT TO100W20-5
200W100-2
400W5A216W72-3
EXCEEDEXCEED200W50-4
NOT TONOT TO216W36-6
200W20-10
400W200-2
800W9.5A400W100-4
432W72-6
EXCEEDEXCEED400W50-8
NOT TO NOT TO 432W36-12
400W20-20
Max InputMax Input CurrentOutput Power (Max) Model Power
Table 1.1
1.4.3 ENVIRONMENTAL REQUIREMENTS
OPERATING TEMPERATURE: 0 to 50 DEGREES CENTIGRADE
STORAGE TEMPERATURE -40 to 85 DEGREES CENTIGRADE
1.4.4 ISOLATION REQUIREMENTS
ISOLATION FROM GROUND: INPUT/GROUND 1500 VAC
OUTPUT/GROUND 1000 VAC
Page 2 of 24
83-469-001 Rev. B