User Manual

14
Reassembly
1. Place the new compressor assembly (508525) onto the silicone isolation mount (508554).
2. Connect the hose from the compressor inlet filter assembly (508611) onto the compressor pressure inlet elbow
(505806).
3. Connect the hose from the cooling coil (508677) onto the compressor pressure outlet elbow (505806). Place new zip-
tie (502776) around the tubing on the compressor pressure outlet elbow. Make sure the zip-tie is squeezing the tube
tightly.
4. Connect the hose from the manifold vacuum outlet elbow (505482) to the compressor vacuum inlet. Place new zip-tie
(502776) around the tubing on the compressor vacuum inlet.
5. Press down on the compressor assembly (508525) to secure it on the silicone isolation mount (508554) and insert the
2 screws (503264) that hold the compressor to the silicone mount.
6. Connect the compressor assembly wires into the bottom of the PC board.
7. Insert the screw (503956) holding the PC board onto the battery separator plate (508539).